PRO-1070   2007 - 2011

Boost Kit

[star rating="0"]


The best just got better. Here is the complete Stage 3 upgrade package with everything you need to crank up the power even further on your 3.8L JK. This will raise the boost level from 8lbs to 12lbs and give you an additional 75rwhp and 60lbft of torque. We are still exploring the limitations of the 3.8L engine. Our in house turbo Jeep now his this setup for over 60,000 miles. We found the first area that needed attention was the factory head bolts. These are typically weak and do not provide the necessary clamping force to sustain the turbo Jeep at high boost levels. We had ARP custom make a set of head studs that would not stretch under high cylinder pressures. Then we needed to make sure proper fuel delivery was being achieved. We found the best way to make sure the fuel pressure did not fall off was to add a boost pump. This is an electric device that cranks up the supply voltage to the fuel pump to 17V. Finally we changed the wastegate spring, strapped it to the dyno and wrote a full custom tune to recalibrate the computer for the new power level of our turbo Jeep. The 12psi upgrade can be installed in a few hours and it comes with a new tune that you load to your Diablosport Intune from anywhere in the world via email. *This upgrade is only available for the manual transmission.

Out of stock



Out of stock


Boost Kit for PRO-1002 Upgrade to Stage 3 

16 custom Prodigy Performance ARP cylinder head studs for increased clamping force.
12PSI Wastegate Spring Kit
Boost Pump that raises the fuel pump voltage on demand for adequate fuel delivery
Exhaust Manifold gaskets
Valve Cover gaskets
ARP Moly Lube
Prodigy Performance 12PSI custom tune
Detailed installation instructions


There are no reviews yet.

Be the first to review “Boost Kit”

Your email address will not be published. Required fields are marked *

Go to Top